Das Projekt „Industrie 4.0 Monitoring-System“ (Erforschung intelligenter Softwarealgorithmen, Ziel: maximale Maschinenverfügbarkeit) wurde von der Europäischen Union aus dem Europäischen Fonds für regionale Entwicklung und dem Land Rheinland-Pfalz gefördert.

Press Release 01/2020

Neustadt-Fernthal, January 2020

New special model BOY 35 E PRO – make a price request online


With the market launch of the BOY 35 E PRO (350 kN clamping force), the specialist of injection moulding machines from 63 to 1250 kN clamping force sets new standards. With the BOY 35 E PRO the machine manufacturer located in Neustadt-Fernthal is going to expand its range of efficient and compact BOY injection moulding machines in spring 2020.

This injection moulding machine is only available with the SP 96 injection unit and the screw diameters from 24 to 32 mm. The basic equipment of the special model BOY 35 E PRO already includes:
-    Highly wear-resistant thermoplastic unit (screw-Ø 24, 28 or 32 mm)
-    Open nozzle with R 35 mm standard, alternatively R ½ "
-    Mould installation height reduced by 50 mm can be selected (150 instead of 200 mm)
-    Control Procan ALPHA ® 2

A total of seven additional options are available, such as a handling-interface according to Euromap 67, a core pull control as well as four freely programmable inputs / outputs.

Make a price request online via the machine manufacturer's website. (www.dr-boy.de/bestellung) for this limited special model with the equipment mentioned before.

With a footprint of just 1.96 m², the compact, four-tie-bar injection moulding machine has a clamping force of 350 kN and is equipped with the proven Procan ALPHA ® 2 touch control. Powered by an energy-efficient, servo-motor pump drive, the BOY 35 E PRO convinces with a low energy requirement of less than 0.49 kg / kWh (7 + corresponding to classification according to Euromap 60.1).

In a practical application example, reference-measurements were carried out with other drive technologies. The savings potential of the model of the E series with servo-drive was 8,700 kWh annually with 6,000 operating hours p.a. Thus, up to 4.67 tons of CO2 emissions can be saved per year due to the energy consumption that is not required (per kWh = 537 g CO2 according to the conversion factor of the Federal Environment Agency and the KfW) - an extremely positive savings potential for the BOY 35 E PRO.

Another ecological approach of BOY is the unproblematic processing of sustainable materials on BOY injection moulding machines. Here, the machine and drive concept of the BOY 35 E PRO stands in the focus of a resource-efficient production. The objective is the maximum production output on minimum space. In a direct comparison of competitive machines with a clamping force of 350 kN, the footprint of the BOY 35 E PRO (only 1.96 m²) is up to 40 percent smaller.